• Construction
  • Low-profile die-cast aluminum LED fixture with hinged, removable door and back box. Available from 10W up to 80W. Three half-inch, NP threaded conduit entry points included in back box, which mounts to standard 3 1/2” to 4” round and octagonal, 4” square, single gang and masonry junction boxes. Key hole gasket adapts to j-box and wall. Silicone gasket seals the door and back box. Compliance to FDA/USDA requirements and/or NSF splash-zone certification. CSA Listed for Wet Locations – IP67
• Optical
  • Mirrored, anodized reflector located inside silicone-sealed optical chamber to provide maximum efficiency and high illumination. Impact-resistant tempered glass included in optical assembly, meeting IESNA requirements for full cutoff. Solid state LEDs thermally optimized with multiple lumen packages from a warm 3000K LED color temp to a cool 5000K (CCT).

• Electrical
  • 120-277V 50/60Hz. Heat sinking optimization due to LED driver mounted to fixture’s die-cast housing. Thermal management system uses conduction and natural convection to transfer heat away from LED source. Three half-inch NPT threaded conduit entry points allow thru-branch wiring and the back box is an authorized electrical wiring compartment. Vinci-LED luminaires maintain greater than 70% of initial light output after 120,000 hours of operation.
  • Line-Line Surge Protection: 1kV (10W), 2kV (20W-30W), 4kV (50W-80W)
• Finish
  • The Vinci features a super durable DECO Guard carbon bronze powder coat finish which can withstand extreme climate conditions while still maintaining optimal color and gloss retention during the installed life of the fixture.

• Low-profile, sleek design provides a more modern aesthetic compared to traditional wall packs
• Full cutoff light output reduces light pollution, delivering illumination only where it is needed most
• Three housing sizes provide flexibility depending on the desired aesthetic

• Available in 3000K (warm white), 4000K (neutral white) or 5000K (cool white) color temperatures
• Optional FSP-211 motion sensor integrates directly into fixture housing
• Performs at up to 120 lumens per watt
• Type III short IES distribution